LEARN HOW TO FLASH SPD PHONES BY USING MIRACLE BOX

Requirements

• Windows PC
• USB cord
• Spreadtrum phone
• Install Spreadtrum drivers on PC using this guide 
• Miracle Box v2.27A + loader; download 
• Stock ROM for flashing (either in .PAC or .MIRA file format); download 

Note

• If you get the inactive start button error when using Miracle Box, then see 
• This guide might not work for some latest SPD devices, for those, you would need a higher version of Miracle Box
• After flashing successfully, first time boot can take a while

How to flash a Spreadtrum Android phone Using Miracle Box

1. Extract the content of the Miracle Box zip into a folder and launch Miracle loader exe
   
   
2. The Miracle Box Window should open
   
   
3. Click on the SPD tab
   
   
4. Tick the checkbox beside Write
   
   
5. Select the phone's chipset type from the dropdown bar
   
   
6. Click on the small browse folder button
   
   
7. In the window that opens next, select the .pac or .mira firmware file then Click on Open
   
   
8. Click on the Start button
   
   
9. You should now see >> "Scanning USB Serial port..." at the bottom left hand corner. Hold the vol down button on your phone and Connect the phone to the PC (must be switched off with battery inside)
   
   
10. A small windows should pop up. Select the items / partitions you wish to flash then click OK
    
    
11. Wait for the writing process to complete
    
    
12. Once successful, you should get a "Write Completed" message
    
    
13. You can now disconnect and power on the phone.
14. download miracle box here